Uncategorized

Developing a Smok Pen

smok pen

Developing a Smok Pen

The Smok Pen is really a revolutionary vaporizing pen which allows for a write-to-write experience, even while you are away from home. This is because of the unique design of the pen. It has two tanks, one smaller compared to the other, that house the e juice and charged batteries. When the user really wants to write, he just places the pen in to the smaller tank and places the ink in the chamber where it will be vaporized. He simply turns on the pen and writes as if he could be writing under a black mirror.

One of the biggest attributes of the Smok Pen is its capability to charge while it is on your desk. This is due to the coils on the Smok Pen are designed in a way to keep the e juice from dripping onto the table or somewhere else. This is because of the 0.3-ohm coil that is placed in the Smok Pen. The 0.3-ohm coil means that even the slightest of air currents won’t affect the writing process. The reason being the electronic circuitry has protection built in so that it will not be affected by extremely low voltage electric currents.

The Smok Pen could be charged internally with a charger or via the USB connection that comes with it. Because the electronic circuitry includes a safety barrier built in, because of this there is no risk involved when charging the device through the computer. The Smok Pen has a charging capacity of sixteen 50 mah batteries, that is great for all pens that use one or two batteries.

To keep the Smok Pen doing work for an extended period of time it is important you don’t overcharge the battery. Overcharging the battery will certainly reduce the voltage that’s available and may eventually result in the device malfunctioning. Overcharging the Smok Pen may also affect the vaporizing process. If you feel that your battery is not getting the vapor it should, remove the pen from the power source and let it cool down for a couple minutes.

The fire button on the Smok Pen is situated in the bottom right corner of the device. The fire button has an orange light, which indicates that it is on. You can press this button to activate the electronic heating element which will let you vaporize the oil. When you have done so you can remove the coil from the holder and place it into the holder and place the Smok Pen in to the airflow chamber, that will cause the heating element to start out heating up and burning off the wick.

When the coil is taken off the holder the airflow chamber is ready for the sub-ohm cartridge. The coils are placed inside the holder and they get heated from the airflow. After they get hot they begin to turn blue, which is the indication that it is ready for the pen’s battery. Ensure that you place your sub-ohm into the chamber before you push the fire button. If you don’t put the coil into the airflow chamber then the oil will leak and cause the leaking of e-juice.

Before you put the battery into the pen, you must make sure that you have disconnected each of the leads. Then you need to remove the Smok Pen’s cap and locate the leak or drip tip. You need to clean this with a little cotton bud, so that you could get rid of the leak. Then reattach the cap back again to the Smok Pen and you also are prepared to place the battery in to the pen.

The final the Puff Bar main construction process is the adapter plate, which fits in to the Smok Vaporizer’s USB port. This plate enables you to charge your e-juice during your computer, so long as you have an adapter for USB connection. I really like this part as it allows me to charge my entire kit at once without worrying about running out of power or constantly running out of e-juice.

Close